A twenty-minute tune-up twice a year catches the wear that turns into a six-a.m. spring failure. It's the cheapest visit we do and the one that prevents the rest.
We treat maintenance visits with the same thoroughness as a diagnostic repair call.
We disconnect the opener and lift the door by hand to verify it holds position, the real test of proper spring balance.
Loose hardware and dry moving parts are two of the most common causes of premature wear we catch during maintenance.
We provide the same level of documentation on a maintenance visit as we would on a repair.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
A full mechanical check and lubrication service recommended twice a year to catch wear before it becomes a failure.
We verify spring balance with the opener disconnected, then adjust opener force and limit settings to match.
We torque-check every accessible fastener and inspect brackets for early signs of fatigue.
Proper lubrication reduces noise and wear significantly, and it's one of the most cost-effective maintenance steps available.
Replacing a near-failure part during routine maintenance avoids the cost and inconvenience of an emergency call later.
Call +1-831-293-1591 →A quick call sets up a seasonal tune-up appointment on your schedule.
A stocked van means any small issue found during the visit can often be fixed on the spot.
We run the full inspection checklist and flag anything needing attention, with any recommended fix quoted upfront.
You'll know exactly what was done and what to watch for before the next scheduled visit.
“Balance test showed the spring was getting weak. Glad we replaced it before it failed completely.”
“Appreciated the written report showing exactly what was checked and what's in good shape.”
“Been getting the seasonal tune-up for three years now and haven't had a single breakdown.”
Annual maintenance is the minimum; twice a year is better for doors used multiple times daily.
A full mechanical inspection, manual balance test, lubrication of all moving parts, and a hardware torque check.
Catching a spring at 80 to 90 percent of its cycle life avoids the surprise of a sudden failure.
Yes, many issues develop gradually and aren't obvious until they cause a failure. Maintenance catches them early.
Maintenance visits are priced as a flat rate, confirmed before scheduling, separate from any additional repair found.
We'll explain what was found, quote the fix, and let you decide whether to address it now or schedule separately.
Call now for a real appointment window, not a callback promise.
☎ Call +1-831-293-1591From one side of Selmer to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Selmer, TN